Asus M4A87T PLUS - Power Management Settings; ACPI and APM Configuration

2-16 Chapter 2: BIOS information
2.5.1 Suspend Mode [Auto]
Selecta the Advanced Conguration and Power Interface (ACPI) state to be used for system
suspend. Conguration options: [S1 (POS) Only] [S3 Only] [Auto]
2.5.2 ACPI 2.0 Support [Enabled]
Enables or disables the Advanced Conguration and Power Interface (ACPI) 2.0 support.
Conguration options: [Disabled] [Enabled]
2.5 Power menu
The Power menu items allow you to change the settings for the Advanced Conguration and
Power Interface (ACPI) and the Advanced Power Management (APM). Select an item then
press <Enter> to display the conguration options.
Select Screen
Select Item
+- Change Option
F1 General Help
F10 Save and Exit
ESC Exit
v02.61 (C)Copyright 1985-2010, American Megatrends, Inc.
Suspend Mode [Auto]
ACPI 2.0 Support [Enabled]
ACPI APIC support [Enabled]
APM Conguration
HW Monitor Conguration
Select the ACPI state
used for System
Suspend.
M4A87T PLUS BIOS Setup
Main Advanced Power Boot Tools Exit
Power Settings
Version 0203
The following items only appear when a USB storage device is plugged in.
USB Mass Storage Device Conguration
USB Mass Storage Reset Delay [20 Sec]
Sets the maximum time that the BIOS waits for the USB storage device to initialize.
Conguration options: [10 Sec] [20 Sec] [30 Sec] [40 Sec]
Emulation Type [Auto]
Allows you to set the emulation type. Conguration options: [Auto] [Floppy]
[Forced FDD] [Hard Disk] [CDROM]