Asus M4A88TD-M EVO USB3 - Page 41

10. Power, CPU, and chassis fan connectors (3-pin PWR_FAN, 4-pin CPU_FAN,
3-pin CHA_FAN)
Connect the fan cables to the fan connectors on the motherboard, ensuring that the
black wire of each cable matches the ground pin of the connector.
Only the 4-pin CPU fan and chassis fan supports the ASUS FanXpert feature.
DO NOT forget to connect the fan cables to the fan connectors. Insufcient air ow inside
the system may damage the motherboard components. These are not jumpers! DO NOT
place jumper caps on the fan connectors.
11. IEEE 1394a port connector (10-1 pin IE1394_1)
This connector is for an IEEE 1394a port. Connect the IEEE 1394a module cable
to this connector, then install the module to a slot opening at the back of the system
chassis.
Never connect a USB cable to the IEEE 1394a connector. Doing so will damage the
motherboard.
The IEEE 1394a module is purchased separately.
ASUS M4A88TD-M EVO 1-29