Asus P11C-I - Chassis Intrusion (2-Pin INTRUSION); NGFF) Connector (NGFF1)

2-30
Chapter 2: Hardware Information
9. M.2 (NGFF) connector (NGFF1)
ThisconnectorallowsyoutoinstallanM.2device.
Thisconnectorsupportstype2242devicesonbothPCI-EandSATAinterface.
• TheM.2(NGFF)deviceispurchasedseparately
• WhentheM.2connectorisoperatinginSATAmode,SATAconnector5(SATA5
Gbps_6)willbedisabled.
10. Chassis Intrusion (2-pin INTRUSION)
These leads are for the intrusion detection feature for chassis with intrusion sensor or
microswitch.Whenyouremoveanychassiscomponent,thesensortriggersandsends
ahighlevelsignaltotheseleadstorecordachassisintrusionevent.Thedefaultsetting
isshortCHASSIS#andGNDpinbyjumpercaptodisablethefunction.