ASUS P4P800 SE motherboard
5-19
2. Key-in a unique name for your RAID volume then press <Enter>.
3. Use the Up and Down arrow keys to select your desired RAID Level
then press <Enter>.
4. If you selected RAID 0 (Stripe), use the Up and Down arrow keys to
select the stripe size for your RAID 0 array then press <Enter>.The
available values range from 8 KB to 128 KB. The strip value should be
chosen based on the planned drive usage. Some suggested selections
are listed below. The default selection is 64 KB.
• 16 KB - low disk usage
• 64 KB - typical disk usage
• 128 KB - performance disk usage
5. On the Create Volume prompt, press <Enter> to create the array. The
utility prompts a confirmation message, press <Y>.
Are you sure you want to create this volume (Y/N)
6. Select 4 Exit then press <Enter> to exit the RAID configuration utility.
The utility prompts a confirmation message, press <Y>.
5.6.5 Deleting a RAID Volume
[
HELP
]
Deleting a volume will destroy the volume data on the drive(s) and
cause any member disks to become available as non-RAID disks.
WARNING:EXISTING DATA WITHING THIS VOLUME WILL BE LOST AND NON-RECOVERABLE
Copyright(C) 2003 Intel Corporation. All Rights Reserved. v3.x.x.xxxx
[
DELETE ARRAY MENU
]
[ ]-Change
[TAB]-Next
[<ESC>]-Previous Menu
[<DEL>]-Delete Volume
Name Level Drives Capacity Status Bootable
RAID_Volume1 RAID0(Stripe) 2 149.0GBNormal Yes
Take caution in using this option; All data on the RAID drives will be
lost!
To delete a RAID volume:
1. Select 2 Delete RAID Volume then press <Enter>.
To Next Page
Loading...
Need help?
General
