Asus P5B SE - Motherboard - ATX - 5.4.3 JMicron RAID Configuration; Before creating a RAID set

5-22 Chapter 5: Software support
SATA Conguration
SATA Conguraton [Enhanced]
Congure SATA as [IDE]
Hard Disk Write Protect [Disabled]
IDE Detect Time Out (Sec) [35]
JMB363 RAID Controller [Enabled]
JMB363 Mode Select [RAID]
Options
Disabled
Compatiable
Enhanced
5.4.3 JMicron
®
RAID Conguration
The JMicron
®
Serial ATA controller allows you to configure RAID 0, RAID 1, and
JBOD sets on the external Serial ATA hard disk drives.
Before creating a RAID set
Prepare the following items:
1. Two SATA HDDs, preferably with the same model and capacity.
2. A write-enabled floppy disk
3. Microsoft
®
Windows
®
OS installation disk (Windows 2000/XP)
4. Motherboard support CD with JMB363 driver
Complete the following steps before you create a RAID set:
1. Install an internal Serial ATA hard disk drive and an external Serial ATA hard
disk drive on your system.
2. Enable the
JMB363 RAID Controller
item in the BIOS, and set the
JMB363
Mode Select
item to [RAID]. See section “
4.3.5 IDE Conguration
” for
details.
3. Enter the JMB363 RAID BIOS utility to set up your RAID configuration.
4. Create a JMB363 RAID driver disk for Windows
®
OS installation. See section
“5.5 Creating a RAID driver disk” for details.
5. Install the JMB363 driver after the Windows
®
OS had been installed.
Install the internal Serial ATA hard disk drive to the SATA connector labeled
SATA_E1.