Asus P5BV-M - Page 76

4-20 Chapter 4: BIOS setup
Memory Remap Feature [Enabled]
Allows you to enable or disable the remapping of the overlapped PCI memory
above the total physical memory. Enable this option only when you install 64-bit
operating system. Conguration options: [Disabled] [Enabled]
DRAM Frequency [Auto]
Allows you to set the DDR operating frequency.
Conguration options: [Auto] [667 MHz] [800 MHz]
Congure DRAM Timing by SPD [Enabled]
When this item is enabled, the DRAM timing parameters are set according to the
DRAM SPD (Serial Presence Detect). When disabled, you can manually set the
DRAM timing parameters through the DRAM sub-items.
Conguration options: [Enabled] [Disabled]
Initiate Graphic Adapter [PEG/PCI]
Allows you to select the graphics controller as the primary boot device.
Conguration options: [PCI/PEG] [PEG/PCI]
PEG Port Conguration
PEG Port [Auto]
Conguration options: [Auto] [Disabled]
SouthBridgechipsetConguration
SMBUSController [Enabled]
SLP_S4#Min.AssertionWidth [1to2seconds]
South Bridge Confi gura tion
SMBUS Controller [Enabled]
Allows you to enable or disable the SMBUS Controller.
Conguration options: [Disabled] [Enabled]
SLP_S4# Min. Assertion Width [1 to 2 seconds]
Allows you to select the SLP_S4# Min. Assertion Width.
Conguration options: [4 to 5 seconds] [3 to 4 seconds] [2 to 3 seconds]
[1 to 2 seconds]