Asus P5N73-CM - Page 33

ASUS P5N73-CM 1-23
3. Serial ATA connectors (7-pin SATA1-4)
These connectors are for the Serial ATA signal cables for Serial ATA hard disk drives.
Connect the right-angle side of SATA signal cable to
SATA device. You may also connect the right-angle
side of SATA cable to the onboard SATA port to avoid
mechanical conict with huge graphics cards.
4. Chassis intrusion connector (4-1 pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor or switch. Connect
one end of the chassis intrusion sensor or switch cable to this connector. The chassis
intrusion sensor or switch sends a high-level signal to this connector when a chassis
component is removed or replaced. The signal is then generated as a chassis intrusion
event.
By default, the pin labeled “Chassis Signal” and “Ground” are shorted with a jumper
cap. Remove the jumper caps only when you intend to use the chassis intrusion
detection feature.
P5N73-CM SATA Connectors
R
GND
RSAT
A_TXP2
RSAT
A_TXN2
GND
RSAT
A_RXP2
RSAT
A_RXN2
GND
GND
RSAT
A_TXP3
RSAT
A_TXN3
GND
RSAT
A_RXP3
RSAT
A_RXN3
GND
GND
RSAT
A_TXP1
RSAT
A_TXN1
GND
RSAT
A_RXP1
RSATA_RXN1
GND
GND
RSAT
A_TXP4
RSAT
A_TXN4
GND
RSAT
A_RXP4
RSATA_RXN4
GND
SATA2
SATA3
SATA1 SATA4
P5N73-CM
CHASSIS
+5VSB_MB
Chassis Signal
GND
(Default)
P5N73-CM Intrusion Connector
R
P5N73-CM