Asus P5N73-CM - APM Configuration

ASUS P5N73-CM 2-19
2.5.1 ACPI Suspend Type [S1&S3]
Allows you to select the Advanced Conguration and Power Interface (ACPI) state to be used
for system suspend. Conguration options: [S1(POS)] [S3(STR)] [S1&S3]
2.5.2 ACPI APIC Support [Enabled]
Allows you to enable or disable the Advanced Conguration and Power Interface (ACPI)
support in the Application-Specic Integrated Circuit (ASIC). When set to Enabled, the ACPI
APIC table pointer is included in the RSDT pointer list. Conguration options: [Disabled]
[Enabled]
2.5.3 APM Conguration
Restore on AC Power Loss [Power Off]
When set to Power Off, the system goes into off state after an AC power loss. When set to
Power On, the system goes on after an AC power loss. When set to
Conguration options: [Power Off] [Power On] [Last State]
PWR Button < 4 secs [Instant-Off]
Allows you to set the event after the power button is pressed for more than 4 seconds.
Conguration options: [Suspend] [Instant-Off]
Power On By PCI/PCIE Devices [Disabled]
Allows you to enable or disable the PME to wake up from S5 by PCI/PCIE devices & NV
Onboard LAN. Conguration options: [Disabled] [Enabled]
Power On By External Modems [Disabled]
This allows either settings of [Enabled] or [Disabled] for powering up the computer when the
external modem receives a call while the computer is in Soft-off mode. Conguration options:
[Disabled] [Enabled]
The computer cannot receive or transmit data until the computer and applications are fully
running. Thus, connection cannot be made on the rst try. Turning an external modem
off and then back on while the computer is off causes an initialization string that turns the
system power on.
Power On By RTC Alarm [Disabled]
Allows you to enable or disable the power on by RTC alarm.
Conguration options: [Disabled] [Enabled]
The following items become user-congurable when the Power On By RTC Alarm item is
set to [Enabled].
Date (of Month) Alarm [0]
To set the date of alarm, highlight this item and press <Enter> to display the Date
of Month Alarm pop-up menu. Key-in a value within the specied range then press
<Enter>. Conguration options: [Min=0] [Max=31]