Asus P5SD1-FM2 - Serial ATA Connectors

ASUS P5SD1-FM2 1-29
Connector Color Setting Use
SATA1 , SATA2 Blue Master Boot Disk
SATA3, SATA4 Black Slave Data Disk
Serial ATA Master/Slave connectors
4 . Serial ATA connectors
(7-pin SATA1 [blue], SATA2 [blue], SATA3 [black],
SATA4 [black])
These connectors are for the Serial ATA signal cables for Serial ATA
hard disk drives.
Important notes on Serial ATA
• The Serial ATA RAID feature (RAID 0, RAID 1) is available only if you
are using Windows
®
XP.
• Install the Windows
®
XP Service Pack 1 before using Serial ATA.
• Use only a maximum of two ports for each RAID 0 or RAID 1 set.
• Plug your Serial ATA boot disk on the master port (SATA1 and
SATA2) to support S3 function. Refer to the table below for details.
These connectors are set to Standard IDE configuration by default. In
Standard IDE mode, you can connect Serial ATA boot/data hard disk
drives to these connectors.
P5SD1-FM2
®
P5SD1-FM2 SATA connectors
SATA1
GND
RSATA_TXP1
RSATA_TXN1
GND RSATA_RXP1
RSATA_RXN1
GND
SATA4
GND
RSATA_TXP4
RSATA_TXN4
GND
RSATA_RXP4
RSATA_RXN4
GND
SATA3
GND
RSATA_TXP3
RSATA_TXN3
GND
RSATA_RXP3 RSATA_RXN3
GND
SATA2
GND
RSATA_TXP2
RSATA_TXN2
GND
RSATA_RXP2
RSATA_RXN2
GND
This Manual: http://www.manuallib.com/file/2595652