Asus PG191 - Chapter 3: General Instruction; OSD (On-Screen Display) Menu; How to Reconfigure; OSD Function Introduction

3-23-2
3-23-2
3-2
Chapter 3: General InstructionChapter 3: General Instruction
Chapter 3: General InstructionChapter 3: General Instruction
Chapter 3: General Instruction
3.1 OSD (On-Screen Display) menu
3.1.13.1.1
3.1.13.1.1
3.1.1
How to reconfigureHow to reconfigure
How to reconfigureHow to reconfigure
How to reconfigure
1. Touch the sensor to activate the OSD menu.
2. Touch
and to navigate through the functions. Highlight and
activate the desired function by touching the sensor. If the
function selected has a sub-menu, touch and again to
navigate through the sub-menu functions. Highlight and activate the
desired sub-menu function by touching the sensor.
3. Touch
and to change the settings of the selected function.
4. To exit the OSD menu, touch the
sensor. Repeat step 2 and step 3
to adjust any other function.
3.1.23.1.2
3.1.23.1.2
3.1.2
OSD function introductionOSD function introduction
OSD function introductionOSD function introduction
OSD function introduction
See the table on the next page for details.
• Phase adjusts the phase of the pixel clock signal. With a wrong
phase adjustment, the screen shows horizontal disturbances.
• Clock (pixel frequency) controls the number of pixels scanned by
one horizontal sweep. If the frequency is not correct, the screen
shows vertical stripes and the image is not proportional.