Asus PG27AQDM - Page 10

10
Assemble joystick key to display key pcb. Lock 2 screws and assemble key pcb
to rear cover and stick deco mylar.
By Screw driver
Screw: T2.5x5
Force: 2-3 kgf.cm
Step 2. Lock 11 screws and assemble MID FRAME and LCM.
By Screw driver
Screw: M3x4
Force:4-5 kgf.cm
Step.3 Lock 2 screws and then assemble the main-board to shielding.
By Screw driver
Screw: M3x5
Force: 5-7 kgf.cm
Step.4 Insert LVDS FFC 51P & LVDS FFC 41P & panel power connector then lock
4 screw.
By Screw driver
Screw: M3x4 / T3x6
Force:4-5 kgf.cm