Asus PG27AQDM - Disassembly and Assembly Procedures; Disassembly Procedure

6
3. Disassembly and Assembly Procedures
3.1 Disassembly Procedure
Preparation before disassemble
1.Clean the room for disassemble
2.Identify the area for monitor
3.Check the position that the monitors be placed and the quantity of the monitor; prepare the area for material flow; according
to the actual condition plan the disassemble layout
4.Prepare the implement, equipment, and materials as below:
1) Working table
2) Screw-driver
3) Glove
4) Cleaning cloth
5) ESD protection
Step
Tool
Note
Step. 1 Unscrew one screws then pull out the Stand Base. Press release button
then pull out the Stand Riser. (Advised tools: By hand or screw-driver.)
By hand or
By Screw driver
Stand Base Screw: M5 x 25
Screws are on Stand
Riser/Base and can not be
removed.
Step.2 Unscrew two screws and separate hooks between MID_FRAME and
R/C . The position of the hook removal slot is at the bottom of left and right.
By Bar Scraper
Screw: M4x10
Force: Force:5-7 kgf.cm