Asus PG27AQDM - Page 8

8
Step.7 Disassembly display key board / stand power board / led board.
Remove deco mylar and unscrew 2 screws and disassemble key pcb from rear
cover. Separate joystick key from display key pcb.
By Screw driver
Screw: T2.5x5
Force: 2-3 kgf.cm
Unscrew 2 screws and disassemble stand power pcb from rear cover.
By Screw driver
Screw: T3x6
Force: 3-4 kgf.cm
Unscrew 3 screws and disassemble ROG cover / led pcb from rear cover.
By Screw driver
Screw: T3x6
Force: 3-4 kgf.cm