GT-AXE16000
ROG Rapture Quad-band Gaming Router
Quick
Start Guide
Hardware Explanations
10GE Port WAN Type Setup Steps
DC Power adapter DC Output: +19V with max 3.42A current
DC Output: +19.5V with max 3.33A current
Operating Temperature 0~40
o
C Storage 0~70
o
C
Operating Humidity 50~90% Storage 20~90%
Specications:
Router Setup Steps
Prepare your Modem
01
1
Unplug the power of cable / DSL modem.
5
[App] Launch ASUS Router App and follow
the instructions to complete the setup.
Modem back
Install your Router
02
1
Plug the adapter into the DCIN port, and press the Power switch.
2
Connect your modem to the
WAN port at the back side of the
router with the network cable
provided.
3
Power on the modem. Plug
modem to the power outlet and
power on.
Modem back
4
Check the modem LED lights to ensure the connection is active.
If you are using DSL for internet,
you will need your username
/ password from your Internet
service provider (ISP) to properly
configure your router.
Modem front
– Or via web browser
3
[Wired] Connect your PC to a LAN port at
the back side of the router using an additional
network cable.
[Wireless] Connect to the network with default SSID
shown on the product label on the back side of your
router “ASUS_XX”.
4
[Wired / Wireless] Open a web browser.
You will be redirected to the ASUS Setup Wizard. If not, navigate to
http://router.asus.com.
Follow the instructions to
complete the setup.
– Via app
3
[App] On your iOS or Android mobile device, go
to the app store, search forASUS Router, and
download the app.
4
[App] On your iOS or Android mobile device, tapSettings > Wi-Fi,
connect to the default network SSID shown on the product label on
the back side of the router. Or scan the QR code on the product label
to connect the default network SSID.
* XX refers to the last two
digits of 2.4GHz MAC
address. You can find it
on the label on the back
of your ROG router.
ROG
GT-AXE16000
_
2
The power LED will light up when the hardware is ready.
ROG
GT-AXE16000
Power
switch
1GE LAN ports
Power (DCIN) port
Reset button
10GE ports
2.5 / 1GE WAN
(Internet) port
2.5 / 1GE
WAN (Internet)
LED
LAN
LED
10GE LED
6GHz/ 5GHz-2/
5GHz-1/ 2.4GHz
Wi-Fi LED
WPS button
LED button (LED Key)
* If no 6GHz SSID is displayed, please check whether your OS and client device are fully licensed to support the newly
released 6GHz band. You can check with your OS and client device provider for Wi-Fi 6E driver release schedule.
USB
3.0 port
USB
2.0 port
Power LED
Connect to the 10GE port
Connect the modem to the 10GE port with a network
cable.
Login and Connect
1
[ASUS Setup Wizard] Select “Manual Setting”.
2
[ASUS Setup Wizard] Select “10G Ethernet”, then follow the instructions
to complete the setup of SSID and login information.
Set up 10GE WAN connection
01
– Under factory defaults
To Next Page
Need help?
General
Weight and Dimensions
