Asus ROG STRIX B365-G GAMING - PCH-FW Configuration; Onboard Devices Configuration; APM Configuration

3-16
Chapter 3: BIOS Setup
Chapter 3
3.6.7 Onboard Devices Configuration
The items in this menu allow you to switch between PCIe Lanes and congure onboard
devices.
HD Audio Controller
This item allows you to use the Azalia High Denition Audio Controller.
Conguration options: [Disabled] [Enabled]
M.2(WIFI) & PCIEX16_2 slot bandwidth configuration
[Auto mode] If a device is inserted in the M.2(WIFI) slot, it will auto-detect and
PCIEX16_2 will run at x2.
[x4 mode] PCIEX16_2 will run at x4, M.2(WIFI) slot will be disabled.
M.2_1 Configuration
[Auto] Auto-detects the M.2 device mode. If a SATA device is detected,
SATA6G_1 will be disabled.
[SATA mode] Only supports M.2 SATA devices. Please note that SATA6G_1 port
cannot be used in this mode.
[PCIE mode] Only supports M.2 PCIE devices.
RGB LED lighting
When system is in working state
This item allows you to turn the RGB LED lighting on or off when the system is in the
working state.
Conguration options: [On] [Off]
3.6.6 PCH-FW Configuration
This item allows you to congure the rmware TPM.
Hot Plug
These items appears only when the SATA Mode Selection is set to [AHCI] and allows
you to enable or disable SATA Hot Plug Support.
Conguration options: [Disabled] [Enabled]
3.6.8 APM Configuration
The items in this menu allow you to set system wake and sleep settings.
ErP Ready
This item allows you to switch off some power at S4+S5 or S5 to get the system ready for
ErP requirement. When set to [Enabled], all other PME options are switched off.
Conguration options: [Disabled] [Enable(S4+S5)] [Enable(S5)]