Asus ROG STRIX Z370-E GAMING - Page 88

4-2
Chapter 4: RAID Support
Chapter 4
4.1.2 InstallingSerialATAharddisks
ThemotherboardsupportsSerialATAharddiskdrives.Foroptimalperformance,install
identicaldrivesofthesamemodelandcapacitywhencreatingadiskarray.
ToinstalltheSATAharddisksforaRAIDconguration:
1. InstalltheSATAharddisksintothedrivebays.
2. ConnecttheSATAsignalcables.
3. ConnectaSATApowercabletothepowerconnectoroneachdrive.
4.1.3 Intel
®
RapidStorageTechnologyinUEFIBIOS
To enter the Intel
®
RapidStorageTechnologyinUEFIBIOS:
1. EntertheBIOSSetupduringPOST.
2. GototheAdvancedmenu > PCHStorageConguration,thenpress<Enter>.
3. SettheSATAControllerModeSelectionitemto[IntelRSTPremiumWithIntel
OptaneSystemAcceleration(RAID)].
4. GototheBoot menu > CSM(CompatibilitySupportModule) > LaunchCSM, then
set the item to [Disabled].
5. SaveyourchangesandexittheBIOSSetup,thenentertheBIOSSetupagain.
6. GototheAdvanced menu > Intel(R)RapidStorageTechnology,thenpress<Enter>
to display the Intel
®
RapidStorageTechnologymenu.
RefertoChapter3fordetailsonenteringandnavigatingthroughtheBIOSSetup
Due to chipset limitation, when SATA ports are set to RAID mode, all SATA ports run at
RAIDmodetogether.