RT-BE88U
BE7200 Dual Band Wi-Fi Router
Quick
Start Guide
Hardware Explanations
I/O Ports Overview LED Lights Overview
DC Power adapter DC Output: +19.5V with 2.31A current
DC Output: +12V with 5A current
Operating Temperature 0~40
o
C Storage 0~70
o
C
Operating Humidity 50~90% Storage 20~90%
Specications:
Router Setup Steps
Prepare your Modem
01
1
Unplug the power of cable / DSL modem. If it
has a battery backup, remove the battery.
5
[App] Launch ASUS Router App and follow the
instructions to complete the setup.
Modem back
Install your Router
02
1
Plug the adapter into the DCIN port, and press the Power switch.
2
Connect your modem to WAN port at the back side of the router with the
network cable provided.
3
Power on the modem. Plug modem to the power outlet and power on.
4
Check the modem LED lights to ensure the connection is active.
If you are using DSL for internet,
you will need your username
/ password from your Internet
service provider (ISP) to properly
congure your router.
Modem front
– Or via web browser
3
[Wired] Connect your PC to LAN port at the back side
of the router using an additional network cable.
[Wireless] Connect to the network with default SSID shown on
the product label on the back side of your router “ASUS_XX”.
4
[Wired / Wireless] Open a web browser.
You will be redirected to the ASUS Setup Wizard. If not, navigate to
http://www.asusrouter.com.
Follow the instructions to
complete the setup.
– Via app
3
[App] On your iOS or Android mobile device, go
to the app store, search forASUS Router, and
download the app.
4
[App] On your iOS or Android mobile device, tapSettings > Wi-Fi, connect
to the default network SSID shown on the product label on the back side of
the router. Or scan the QR code on the product label to connect the default
network SSID.
* XX refers to the last two digits
of MAC address. You can nd
it on the label on the back of
your router.
_
5GHz LED
WAN (Internet)
LED
LAN LED
USB 3.2 Gen 1 LED
Power LED
2
The power LED will light up when the hardware is ready.
DCIN port
1G LAN 5-8
ports
Reset button
WPS button
2.5G WAN/LAN 1
port
USB 3.2 Gen 1 port
(USB 3.0)
2.5G LAN 2-4
ports
10G
LED
2.4GHz LED
Modem back
http://www.asusrouter.com/
E23287
Power switch
10G SFP+
10G WAN/LAN
(Internet) port
10G SFP+ LED
Gain Another 10GE LAN Port
Connect to the 2.5GE WAN port
Connect the modem to the 2.5GE WAN port with a
network cable.
Login and Connect
1
[ASUS Setup Wizard] Select “Manual Setting”.
2
[ASUS Setup Wizard] Select “2.5G WAN”, then follow the instructions
to
complete the setup of SSID and login information.
Set up 2.5GE WAN connection to release another 10GE LAN Port
01
– Under factory defaults
To Next Page
Need help?
General
