EasyManua.ls Logo

Asus RTL8822CE - EU and Canadian RF Exposure Information; EU RF Exposure Guidelines; Canada ISED Notices

Asus RTL8822CE
32 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
16
Notebook PC User Guide
Canada, Innovation, Science and Economic
Development Canada (ISED) Notices
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation,
Science and Economic Development Canadas licence-exempt RSS(s). Operation is subject to
the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause
undesired operation of the device.
Radio Frequency (RF) Exposure Information
The radiated output power of the Wireless Device is below the Innovation, Science and
Economic Development Canada (ISED) radio frequency exposure limits. The Wireless Device
should be used in such a manner such that the potential for human contact during normal
operation is minimized.
This device has been evaluated for and shown compliant with the ISED Specic Absorption Rate
(“SAR”) limits when operated in portable exposure conditions.
RF Exposure information (SAR)
This device meets the EU requirements (2014/53/EU) on the limitation of exposure of the
general public to electromagnetic elds by way of health protection.
The limits are part of extensive recommendations for the protection of the general public. These
recommendations have been developed and checked by independent scientic organizations
through regular and thorough evaluations of scientic studies. The unit of measurement for the
European Council’s recommended limit for mobile devices is the “Specic Absorption Rate” (SAR),
and the SAR limit is 2.0 W/Kg averaged over 10 gram of body tissue. It meets the requirements
of the International Commission on Non-Ionizing Radiation Protection (ICNIRP).
For next-to-body operation, this device has been tested and meets the ICNIRP exposure
guidelines and the European Standard EN 50566 and EN 62209-2. SAR is measured with the
device directly contacted to the body while transmitting at the highest certied output power
level in all frequency bands of the mobile device.
A minimum separation distance of 1 cm must be maintained between the user’s body and the
device, including the antenna during body-worn operation to comply with the RF exposure
requirements in Europe.
CA18651_TP1400_1401KA_UM_28pages.indd 16CA18651_TP1400_1401KA_UM_28pages.indd 16 2021/10/22 下午 04:20:232021/10/22 下午 04:20:23

Related product manuals