Asus SABERTOOTH Z170 - Motherboard Installation

SABERTOOTH Z170 S
2-3
Chapter 2
The diagrams in this section are for reference only. The motherboard layout may vary with
models, but the installation steps are the same for all models.
2.1.2 Motherboard installation
1. Match and align four (4) holes of the back I/O dust grid and four (4) fasteners of the
back I/O dust frame then attach the dust grid to the dust frame.
2. Match and align the four (4) fasteners of the back I/O dust frame and grid assembly to
the four (4) circular holes on the back I/O fan vent of the I/O shield then push to fasten
the back I/O dust grid into the I/O shield with the back I/O dust frame.
Back I/O dust frame
Back I/O dust grid
I/O shield
Clean your back I/O dust lter from time to time, especially when it is dirty, to ensure
optimum airow.
3. Install the ASUS Q-Shield to the chassis rear I/O panel.