2-18 Chapter 2: Basic installation
2. Connect the SATA signal
cable and the power plugs to
the connectors at the back
of the drive.
3. Locate the HDD tray.
4. Insert a hard disk drive (with
the HDD PCB facing the top
of the chassis) to the tray,
then secure it with four
screws.
2
4
4
4
4
4
5. Connect the SATA signal
cable to the SATA connector
on the motherboard.
6. Tighten all the cables with the
plastic coils.
6
6
To Next Page
Loading...
