2-17ASUS T3-M2NC51PV
2.8 Installing an optical drive
The barebone system comes with a 5.25-inch drive bays for an optical
drive.
To install an optical drive:
1. Place the chassis upright.
2. Insert the optical drive to the
upper 5.25 in drive bay, then
carefully push the drive until its
screw holes align with the holes
on the bay.
22
3 3
3. Secure the optical drive with
four screws on both sides of the
bay.
4. Connect the IDE and the power
plugs to the connectors at the
back of the drive.
2.9 Installing a hard disk drive (HDD)
The system supports one Serial ATA hard disk drive.
To install an Serial ATA hard disk drive:
1. Connect the SATA power cable
to the plug of the power supply
unit.
1
To Next Page
Loading...
