Asus V-Series P5P43 - 2.10 Installing A Floppy Disk Drive

2-26 Chapter 2: Basic installation
2.10 Installingaoppydiskdrive
The system comes with one 3.25-inch drive bay for a oppy disk drive.
To install a oppy disk drive:
1. Remove the drive slot metal plate cover.
2. Carefully insert the oppy disk drive into the oppy drive bay until the screw
holes align with the holes on the bay.
3. Secure the oppy disk drive with two screws on both sides.
4. Connect the oppy disk drive signal cable to the signal connector at the back
of the drive.
5. Connect the other end of the signal cable to the oppy disk drive connector
on the motherboard. See page 4-6 for the location of the oppy disk drive
connector.
6. Connect a 4-pin power cable from the power supply unit to the power connector
at the back of the oppy disk drive.
Floppy ribbon cable
Power cable
3
3
2
3
3
2
remove the metal
plate cover and
install the card
reader module here