VivoPC VM40B
33
Upgrading memory modules
Your VivoPC comes with two SO-DIMM memory slots that allows
you to install two 2 GB, 4 GB, or 8GB unbuered with non-ECC DDR3
SO-DIMMs (204 pin), for a maximum of 16 GB memory.
IMPORTANT:
• For optimum performance, install identical DDR3 (SO-DIMM)
modules only.
• Always install SO-DIMMs with the same CAS latency.
NOTE: Your VivoPC comes with one (1) pre-installed DDR3 (SO-
DIMM) module.
To install or upgrade the memory modules:
1. Turn o your VivoPC.
2. Disconnect all cables and peripherals.
3. Place the VivoPC on a stable and at surface.
4. Press down latch at the rear panel to release the top cover.
To Next Page
Loading...
