1-2
Chapter 1: Product Introduction
1. Attach the base to the arm.
2. Beware to align the latch to the notch on the base.
3. The end of the arm will slightly protrude from the base. No need to
push it in.
4. Screw the base to the arm tightly.
4
2
1
3
• We recommend that you cover the table surface with soft cloth to prevent
damage to the monitor.
Connect the cables you need based on chapter 1.5.2, page 1-5.
• Flip upward the IO port cover to connect cables. After connected cables,
replace the cover and carefully push it upward to its original position with both
thumbs at both sides of the cover.
To Next Page
Loading...
