3-6
Chapter 3: General Instruction
4. Image
You can adjust the image Sharpness, Trace Free, Aspect Control,
ASCR, Motion Sync, Adaptive-Sync, Position (VGA only), Focus (VGA
only), and Auto Adjust (VGA only), from this main function.
VY229HE
1920 x 1080 60 Hz
Splendid
Standard Mode
Signal
HDMI
Btightness
65
Splendid
EyeCare
Image
Signal
Back/Exit Enter
Color
Aspect Control
Sharpness
Adaptive-Sync
ASCR
Motion Sync
Position
Focus
Trace Free
60
40
• Sharpness: Adjusts the picture sharpness. The adjusting range is from
0 to 100.
• Trace Free: Speeds up the response time by Over Drive technology. The
adjusting range is from lower 0 to faster 100.
• Aspect Control: Adjusts the aspect ratio to “Full”, “1:1 Ratio”.
• ASCR: Select ON or OFF to enable or disable dynamic contrast ratio
function.
• Motion Sync: Check to decrease motion blur and minimize ghosting part
when on-screen objects are fast moving. When this function is turned on,
the screen may flash slightly and the brightness will decrease.
• Adaptive-Sync: It can allow a Adaptive-Sync supported graphics source
to dynamically adjust display refresh rate based on typical content frame
rates for power efficient, virtually stutter free and low-latency display
update.
• Position (VGA only)：Adjusts the horizontal position (H-Position) and
the vertical position (V-Position) of the image. The adjusting range is from
0 to 100 (Only available for VGA input).
• Focus (VGA only)：Reduces Horizonal-line noise and Vertical-line noise
of the image by adjusting (Phase) and (Clock) separately. The adjusting
range is from 0 to 100 (Only available for VGA input).
• Auto Adjust (VGA only)：Automatically adjust the image to its
optimized position, clock, and phase. (Only available for VGA input.)
To Next Page
Loading...
