ASUS Z8NA-D6 Series 2-27
7. DDR3 voltage control setting (4-pin LVDDR3_SEL1; LVDDR3_SEL2)
These jumpers allow you to adjust the DIMM voltage. Set to pins 1–2 to
select 1.5V BIOS control, pins 2–3 to select 1.2V Force or 3–4 to select
1.35V Force.
6. iBTN RAID setting (3-pin IBTN_SEL1)
(Z8NA-D6 model only)
This jumper allows you to select the RAID conguration utility to use when
you create disk arrays. Place the jumper caps on pins 1–2 if you install a
PIKE RAID card to the motherboard and want to use the LSI Logic MPTLSI Logic MPT
Setup Utility (default). (default).
• LSI Logic MPT Setup Utility is available only when you install a PIKE RAID
card.
• LSI Mega RAID 5 fucntion is available only when you place the iBTN to
I_BTN1 slot and install an optional ASUS PIKE RAID card.
To Next Page
Loading...
