Asus Z97-A/USB 3.1 - Page 79

ASUS Z97-A/USB 3.1
2-25
Channel A/B DIMM Control [Enable Both DIMMs]
This item allows you to enable or disable the DIMMs on channels A and B.
Conguration options: [Enable Both DIMMS] [Disable DIMM0] [Disable DIMM1] [Disable Both
DIMMS]
Scrambler Setting [Optimized (ASUS)]
This item allows you to set the optimized mode to enhance system stability.
Conguration options: [Optimized (ASUS] [Default (MRC)]
MCH Full Check [Auto]
Enable this item to enhance the stability of your system. Disable this item to enhance the
DRAM overclocking capability.
Conguration options: [Auto] [Enabled] [Disabled]
Skew Control
The subitems in this menu allows you to enhance the DRAM overclocking capability and
stability. Use the <+> or <-> keys to adjust the value. To restore the default setting, type
[Auto] using the keyboard and press the <Enter> key.
Transmitter Rising Slope [Auto]
Conguration options: [Auto] [1] - [31]
Transmitter Falling Slope [Auto]
Conguration options: [Auto] [1] - [31]
Transmitter Control Time [Auto]
Conguration options: [Auto] [1] - [31]
Receiver Rising Slope [Auto]
Conguration options: [Auto] [1] - [31]
Receiver Falling Slope [Auto]
Conguration options: [Auto] [1] - [31]
Receiver Control Time [Auto]
Conguration options: [Auto] [1] - [31]
2.5.14 DIGI+ VRM
CPU Load-line Calibration [Auto]
Load-line is dened by Intel
®
specication and affects CPU power voltage. The CPU working
voltage decreases proportionally to CPU loading. Higher load-line calibration could get
higher voltage and good overclocking performance, but increases the CPU and VRM thermal
conditions. Select from levels 1 to 9 to adjust the CPU power voltage from 0% to 115%.
Conguration options [Auto] [Level 1] - [Level 9]
The actual performance boost may vary depending on your CPU specication.
DO NOT remove the thermal module. The thermal conditions should be monitored.