6-8 Chapter 6: Driver installation
5. When asked if you will load additional RAID controller drivers, select No, then
press <Enter>.
More Driver Disks?
Do you wish to load any more
driver disks?
Yes No
6. Follow the onscreen instructions to nish the OS installation.
7. When the installation is completed, DO NOT click
Reboot
. Press <Ctrl>
+ <Alt> + <F2> to switch to the command-line interface from graphic user
interface.
8. Type the following commands when using a Legacy oppy.
mkdir /mnt/driver
mount /dev/fd0 /mnt/driver
cd /mnt/driver
sh replace_ahci.sh
reboot
For Red Hat
®
Enterprise Linux OS 6.1
To install the LSI MegaRAID controller driver when installing Red Hat
®
Enterprise
OS:
1. Boot the system from the Red Hat
®
OS installation CD.
2. Press <Tab> to edit options.
To Next Page
Loading...
