ATAG A-Serie
25
In the event of a failure (this is indicated by a c
and number code on the display) you can try to
eliminate the failure by pressing the Reset key. If
the failure persists, please contact your installer
as soon as possible and tell him the number code.
There are also messages with a c and a number
code that constitute no failures. These messages
will cancel themselves over time or after lling (or
draining) the heating system. Operating the reset
button has no effect then, for example:
c1 05 venting program active (approx. 7 min.)
c1 17 water pressure too high
c1 18 water pressure too low
If leaks occur in the installation, please contact
your installer.
Venting program active
Conclude a maintenance agreement with your
installer in order to have the installation periodically
checked and adjusted.
The cover of the boiler consists of plastic parts,
which can be cleaned with a normal (non-
aggressive) cleansing agent.
For the warranty conditions, see the Warranty
Card that has been delivered with the boiler.
9 Errors
10 Maintenance
11 Warranty
ATAGHeatingUKLtd.•Unit3•BeaverTradePark•QuarryLane•Chichester•WestSussex•PO198NY
Phone:01243815770•Fax01243839596•E-mail:info@atagheating.co.uk•Internet:www.atagheating.co.uk
To Next Page
Loading...
Need help?
General
