Atag CM4511AC - Use; Preparation

To Next Page

To Previous Page

EN 10

USE

Preparation

Connect the appliance to the mains supply (see chapter ‘Installation’)

and switch on the appliance with the main switch (see ‘A’ page 5). The

ﬁrst time you switch on the appliance with the main switch and every

time that it is plugged in, the appliance executes a “SELF-DIAGNOSIS”

action. Then the appliance switches off.

To turn it on, press the On/stand by button (Aa) on the left site

underneath the control panel.

• Coffee has been used to factory test the appliance and it is therefore

completely normal for there to be traces of coffee in the mill.

• Customise water hardness as soon as possible following the

instructions in the “Setting water hardness” section.

1. Start the appliance with the on/stand by button (see ‘Aa’). The

appliance displays ‘FILL TANK’ in different languages.

▷ Extract the water tank, rinse and ﬁll with fresh water without

exceeding the MAX line.

▷ Replace and push as far as it will go.

2. Set the required language.

• When the message “PRESS OK TO SET TO ENGLISH” is

displayed, press and hold the touch key ‘Ok’ (5) for about 5

sec. If you set the wrong language, follow the instructions in the

“Setting the language” section. If your language is not available,

select one from those displayed. The instructions refer to the

English version. Then follow the instructions displayed.

3. Place a cup under the hot water spout. If the hot water spout is not

inserted, the appliance displays “INSERT WATER SPOUT”.

4. Place the hot water spout if it is not there.

The appliance displays: “HOT WATER PRESS OK”.

5. Press the touch key ‘OK’ (5) and after a few seconds a little water comes

out of the spout.

6. The machine now displays “TURNING OFF PLEASE WAIT” and

goes off.

7. Extract the appliance by pulling it out using the handles.