EN 12
SAFETY INSTRUCTIONS
Installation of this oven must be performed
only by a licensed electrician. The installer is
responsible for connecting the appliance to
the mains power supply in observance of the
relevant safety recommendations.
Electrical safety
If the oven has been damaged in transport, do
not connect it.
• This appliance must be connected to the
mains power supply only by a specially
licensed electrician.
• In the event of a fault or damage to the
appliance, do not attempt to operate it.
• Repairs should be performed by a licensed
technician only. Improper repair may result
in considerable danger to you and others.
If your oven needs repair, contact the Atag
Customer Service or your dealer.
• If the supply cord is defective, it must be
replaced by a special cord or assembly
available from the manufacturer or an
authorised service agent.
• Electrical leads and cables should not be
allowed to touch the oven.
• The oven should be connected to the mains
power supply by means of an approved
circuit breaker or fuse. Never use multiple
plug adapters or extension leads.
• The rating plate is located on the inside of the
oven on the right side.
• The power supply of the appliance should
be turned off when it is being repaired or
cleaned.
• Take care when connecting electrical
appliances to sockets near the oven.
To Next Page
Loading...
Need help?
General
