Atag SX3211C

GB 19
what to do in case of malfunctions?
In all circumstances, if your efforts are not sufficient,
contact the After-Sales Service Department without delay.
WHAT SHOULD
YOU DO?
POSSIBLE
CAUSES
Your display does not
light up.
The bulb doesn't
work anymore.
Water or steam leak
around the door
during cooking.
Oven is not connected
to power source.
Electronic board is not
functioning.
- Check that the
appliance is receiving
electricity (good
fuse).
- Call the After-Sales
Service Department.
- Change the bulb.
- Connect the oven.
- Change the fuse.
The bulb is out of
order.
The oven is not
connected.
Your fuse is out of
order.
The door is not
properly closed.
The door seal is
defective.
- Call the After-Sales
Service Department.
YOU OBSERVE
THAT…