What to do if the Atag VA63111ST Dishwasher programme does not start?
If your Atag Dishwasher program isn't starting, make sure that the appliance door is properly closed. If the delay start function is activated, either cancel the setting or wait until the countdown is complete.
Why does Atag VA63111ST Dishwasher leave stains and water drops?
If you notice stains and dry water drops on glasses and dishes after using your Atag Dishwasher, try adjusting the rinse aid selector to a higher position. The issue could also be related to the quality of the detergent you're using.
Why are dishes wet after Atag Dishwasher cycle?
If your dishes are wet after a cycle in your Atag Dishwasher, it could be due to several reasons: * The selected program might lack a drying phase or uses a low-temperature drying phase. * The rinse aid dispenser might be empty. * The quality of the rinse aid or the combi detergent tablets could be the issue. Try using a different brand or activate the rinse aid dispenser and use rinse aid along with the combi detergent tablets.
Why is my Atag VA63111ST Dishwasher not filling with water?
If your Atag Dishwasher isn't filling with water, ensure the water tap is fully open. Also, check that the water supply pressure is adequate by consulting your local water authority. Make sure the water tap and the filter in the inlet hose aren't clogged. Finally, confirm that the inlet hose isn't kinked or bent.
How to fix Atag VA63111ST that does not drain water?
If your Atag Dishwasher isn't draining water, check to ensure that the sink spigot isn't clogged. Also, verify that the drain hose isn't kinked or bent.
General| Place settings | 13 |
|---|---|
| Noise level | 44 dB |
| Water consumption per cycle | 9.5 L |
| Noise emission class | B |
| Delay timer | Yes |
| Child lock | Yes |
| Drying system | Condensation |
To Next Page
