dicators of buttons , ,
and start to flash.
3.
Press button
.
•
The indicators of buttons
,
and go off.
•
The indicator of button
con-
tinues to flash.
• The display shows a number and the
letter C. Each number is related to a
different colour (0C = TimeBeam is
deactivated).
4.
To set a colour, press button
again and again to go through the menu
of colours. The different colours show
on the kitchen floor.
5. Press the on/off button to deactivate the
appliance and to confirm the setting.
BEFORE FIRST USE
1. Make sure that the set level of the water
softener agrees with the water hardness
in your area. If not, adjust the water
softener. Contact your local water au-
thority to know the water hardness in
your area.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
4. Open the water tap.
5. Processing residues can stay in the ap-
pliance. Start a programme to remove
them. Do not use detergent and do not
load the baskets.
Adjusting the water softener
Water hardness
Water softener
adjustment
German
degrees
(°dH)
French
degrees
(°fH)
mmol/l Clarke
degrees
Level
47 - 50 84 - 90 8.4. - 9.0 58 - 63 10
43 - 46 76 - 83 7.6 - 8.3 53 - 57 9
37 - 42 65 - 75 6.5 - 7.5 46 - 52 8
29 - 36 51 - 64 5.1 - 6.4 36 - 45 7
23 - 28 40 - 50 4.0 - 5.0 28 - 35 6
19 - 22 33 - 39 3.3 - 3.9 23 - 27
5
1)
15 - 18 26 - 32 2.6 - 3.2 18 - 22 4
11 - 14 19 - 25 1.9 - 2.5 13 - 17 3
4 - 10 7 - 18 0.7 - 1.8 5 - 12 2
< 4 < 7 < 0.7 < 5
1
2)
1) Factory position.
2) Do not use salt at this level.
How to adjust the level of the water
softener
1. Press the on/off button to activate the
appliance. Make sure that the appliance
is in setting mode, refer to “Setting and
starting a programme”.
2. Press and hold, at the same time, but-
ton
and button until the in-
dicators of buttons
, ,
and start to flash.
3.
Press button
.
•
The indicators of buttons
,
and go off.
•
The indicator of button
continues
to flash.
• The acoustic signals operate, e.g. five
intermittent acoustic signals = level 5.
22
To Next Page
Loading...
