4
Handling of this instrument (Continued)
CAUTION
◇ DO NOT measure any sample that can
damage the prism or the sample inlet unit.
◇ Cleaning liquids up to 160˚C can be used
for CIP or SIP. The momentary difference
between the sample liquid temperature
and the cleaning liquid temperature must
be no more than 80˚C.
When using cleaning liquids at
temperatures over 160˚C, the power
source (DC24V) must be turned off. If the
AD-32 (AD-33 or AD-34) is used, unplug
from the outlet before cleaning.
◇ If the sample could possibly stain the
prism, immediately clean the prism
according to the procedure described on
page 36 "17.Cleaning the Prism".
◇ The In-line Monitor power (DC24V)
should be turned off when it is not to be
used for a long period of time. If the AD
adapter AD-32, AD-33 or AD-34 (optional)
is used, disconnect the power cable plug
from the AC 100-240V outlet.
◇ When transporting the instrument, pack it
in the original box.
◇ When transporting by aircraft, disconnect
the power (DC24V) cable or the DC
output cable of the AC adapter AD-32,
AD-33 or AD-34 (optional) from the power
input terminal of the In-line Monitor.
◇ Carefully read this instruction manual and fully understand the function and operation of
each part of the instrument before use.
◇ Check that each part of the instrument operates normally before use.
◇ Perform the necessary inspections and reference adjustments according to the instruction
manual.
◇ The manufacturer shall not be held responsible for any damage that results from using the
instrument for other than its intended purposes (measurement of Brix(%), sugar content,
liquid concentration).
◇ The manufacturer shall not be held responsible if the use of the instrument has an
undesired effect on the measured materials.
◇ The prism in contact with the sample is a consumable item.
To Next Page
Loading...
Need help?
General
