AT&T and the globe symbol are registered trademarks of
AT&T Corp. licensed to Advanced American Telephones.
© 2000 Advanced American Telephones. All rights reserved.
Printed in China. 850005059 Issue 1AT&T 12/00
1
USER’S MANUAL
Part 2
INSTALLATION
Please also read
Part 1 – Important
Product Information.
Design Line
®
Telephone
146
2
4 Pull phone down
onto mounting
studs as shown.
5 Follow Steps 3-5
in Table/Desk,
above.
Table/Desk
Wall
3 Press the cord into the channel as shown,
and connect to the free end of the line cord
to the modular wall jack.
2 Connect the short line cord to the telephone.
1 Reverse the handset tab as shown.
1 Connect the long line cord to the telephone.
2 Press the cord into the channel as shown,
and connect the free end of the line cord
to the modular wall jack.
3 Set the dial mode switch to TONE if you have
touch tone service or to PULSE if you have
dial pulse service.
4 Connect the handset to the base using
the coiled cord. Hang up the handset.
5 Lift the handset and check
for dial tone.
Dial mode
switch
b
c
a
NOTE: If you do
not reverse the
handset tab, the
handset will not
stay in the cradle
when used on a
wall. If you later
move this phone
to a table or desk,
be sure to reverse
the handset tab
again.
Dial
mode
switch
To Next Page
Need help?
General
