EasyManua.ls Logo

AT&T 6100 - Troubleshooting Guide; General Troubleshooting Steps; Re-initializing the Handset and Base; Troubleshooting a Two-Beep Signal

AT&T 6100
17 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Replacing the Handset Battery Pack
1 Remove the battery compartment cover on the handset by
pressing on the indentation and sliding the cover downward.
2 Lift out the old battery pack and disconnect.
3 Align the two holes in the new battery pack’s plug with the
socket pins, and snap the plug into place. Place the battery pack in the
compartment with the wires in the lower left corner, along the bottom
of the battery pack.
4 Replace the cover by sliding it up into place.
5 The new battery pack must be charged before using the phone.
Place the handset in the base and allow it to charge for at least
24 hours the first charge. The telephone might operate before that,
but for best performance, let the battery pack charge fully.
HEADLINE LEFT
HEADLINE L-SUB
14
BATTERIES
6100_book_1ATT 11/25/00 12:37 PM Page 14

Related product manuals