10
Registration and deregistration
Before using a new CL80119 handset, you must register it with the
telephone base rst. The telephone system can support up to 12
handsets.
The handsets provided with your telephone system are already
registered as HANDSET 1, and so forth. Additional handsets
registered to the telephone system are assigned in sequential
order they are registered (up to HANDSET 12).
You must register each handset separately. When rst purchased, all
expansion handsets show To register HS, see manual.
Register a handset to your telephone base for AT&T models
CL82219/CL82229/CL82319/CL82419/CL83519
1. Before you begin registration, make sure the handset is out of the
telephone base or charger and shows To register HS, see manual.
2. Put the handset you wish to register on the telephone base cradle.
3. The IN USE light on the telephone base turns on. The handset
shows Registering... Please wait. When the registration is
successful, the handset shows HANDSET X Registered
(HANDSET represents the handset name, X represents the hand-
set number) and you hear a confirmation tone. The IN USE light
turns off. The handset is now registered with the telephone base.
For registration, put the handset on the
telephone base, not the handset charger.
Adding and registering handsets
To Next Page
Loading...
Need help?
General
