Appendix
Alert tones and lights
Handset alert tones
One short beep Tone of each key press, if key tone is turned on.
One long beep Indication to begin recording a message, memo or announcement.
Two short beeps
You are pressing qCID or pDIR on a cordless handset when the
volume is already at its highest or lowest setting.
-OR-
Call waiting tone.
-OR-
Error tone.
Confirmation tone
(three rising tones)
The system has completed the command successfully.
Four beeps
The other party has ended your intercom call.
-OR-
The handset has gone out of range from the base during a call.
Four short beeps Low battery warning.
Telephone base alert tones
One long beep
Indicates the start of message recording during call screening or
the end of a message playback session.
Four short beeps Registration failure tone.
Beeps every
ten seconds
Message alert.
Fast ringer tone
You are setting the ringer volume by pressing the pVOLUME or
qVOLUME
key on the telephone base.
85
To Next Page
Loading...
Need help?
General
