Appendix
105
The batteries do not hold a charge.
If the cordless handset is in the telephone base or charger and
the charge light is not on, refer to The charge light is off (page
109).
Charge the battery in the cordless handset for at least ten hours.
For optimum daily performance, return the cordless handset to
the telephone base or charger when not in use.
If the battery is depleted, it may take approximately 30 minutes
to charge the handset before it shows Low battery. Refer to the
table on page 8 for details.
You may need to purchase a new battery. Please refer to
Battery installation and charging in this user’s manual on
pages 8-10.
•
•
•
•
Troubleshooting
Out of range OR No pwr at base appears on my cordless
handset.
Ensure you plug the telephone base in properly and the power is
on.
Place the cordless handset in the telephone base for one minute
to allow the cordless handset and base to synchronize.
Move the cordless handset closer to the telephone base. You
may have moved out of range.
Reset the telephone base. Unplug the electrical power. Wait for
15 seconds, then plug it back in. Allow up to one minute for the
cordless handset and telephone base to reset.
Other electronic products such as HAM radios and other DECT
phones, can cause interference with your cordless phone. Try
installing your phone as far away as possible from these types of
electronic devices.
•
•
•
•
•
To Next Page
Loading...
