Answering system
Message playback
To listen to messages on a cordless handset:
1. When the handset is in idle mode, press MENU/SELECT to
enter the main menu.
2. Press MENU/SELECT again to select Play messages.
If there are new and old messages, press qCID or pDIR
to select Play new msgs or Play old msgs, then press
MENU/SELECT.
If there are only new or only old messages, they will
play automatically.
The system announces the number of messages, then
begins playback. The message sequence is shown on the
handset. If there are no recorded messages, the handset
shows No messages and you hear, “You have no message.”
Options during playback
When a message is playing, you can adjust the playback volume, skip, repeat,
pause or delete the message.
When messages are playing on the telephone base:
Press q/VOLUME/p to adjust the message playback volume.
Press /SKIP to skip to the next message.
Press /REPEAT to repeat the message. Press twice to hear the
previous message.
Press X/DELETE to delete the message.
Press /PLAY/STOP to stop the playback.
Press /SPEAKERSPEAKER to stop playback. The screen shows Call back?, then
press MENU/SELECT, or /SPEAKERSPEAKER to call back the caller if the caller’s
number is available. If the dialing format used is not correct, then use the
option below to choose the correct dialing format before calling back
the caller.
Press MENU/SELECT to pause playback and show the caller ID information
if available. From here, you can press CANCEL to resume playback,
or press # (pound key) repeatedly to show the desired dialing option
(page 72), then press /SPEAKERSPEAKER to call back the caller. If you do not
call back within ten seconds, message playback resumes automatically.
•
•
•
•
•
•
•
•
•
>Play new msgs
Play old msgs
ANS ON
3 New messages
ANS ON
You have:
Charlie Johnson
4-Repeat 6-Skip
MSG#
1/3
10:01
AM
NEW
ANS ON
89
To Next Page
Loading...
Need help?
General
