AT&T CL83215 User Manual

Answering system
About the answering system
Call intercept
While screening a call, you can stop recording and speak to the caller by pressing
PHONE/FLASH on the handset or /SPEAKERSPEAKER on the telephone base.
Base ringer
Press q/VOLUME/p on the telephone base to adjust the ringer volume
when the telephone is not in use.
You hear a sample of the ringer while adjusting the volume. The telephone
base shows Ringer off when you set the volume to 0.
Temporarily turning off the message alert tone
If the message alert tone is turned on, the telephone base beeps every
ten seconds when there are new messages. Pressing any telephone base
key (except /HANDSET LOCATOR) temporarily silences the message
alert tone.
If you press X/DELETE when in idle mode to temporarily turn off the
message alert tone, there is a voice prompt directing you to press X/DELETE
again to delete all old messages. The message alert tone is temporarily off.
Only press X/DELETE a second time if you wish to erase all old messages in
your answering system.
The message alert tone resumes when you receive another message.
94

AT&T CL83215 Specifications

General

Color	silver/black
Speakerphone	yes
Expandable	yes
Volume Control	yes
Intercom	yes
Incoming Lines	1
Record Time	22 minutes
Caller ID	yes
Call Waiting	yes
Answering System	yes
Flash Function	no
Conference Call	yes
Caller ID Memory	50 gigabytes
Phone Book Memory	50 gigabytes
Handsets	yes
Expansion Base Stations	1
Expansion Handsets	2, 12
Backlit Keypad	yes
Frequency	dect 6.0 digital
Battery Capacity	400 milliampere hours