Getting started
6
Telephone base installation
Install the telephone base as shown below.
The telephone base is ready for tabletop use. If you want to change to wall
mounting, see page 10 for details.
1. Plug the small end of the
AC power adapter into the
power jack on the bottom
of the telephone base.
2. Plug one end of the
telephone line cord
into the telephone
jack on the bottom of
the telephone base.
4. Place the cords into
the channels.
7. Plug the large end
of the AC power
adapter into a power
outlet not controlled
by a wall switch.
If you have DSL high
speed Internet service,
a DSL filter (not
included) is required.
6. Plug the other
end of the
telephone line
cord into a
telephone jack or
a DSL filter.
3. Plug the other
end of the coiled
handset cord
into the jack at
the left of the
telephone base.
5. Raise the
antenna.
To Next Page
Loading...
