10
Getting started
10
Telephone base and charger installation
Install the telephone base and charger, as shown below.
The telephone base is ready for tabletop use. If you want to change to
wall-mounting, see Installation options on page 17 for details.
Telephone base installation
Raise the antenna.
Plug one end of the
telephone line cord into a
telephone jack or a DSL lter.
Route the power
adapter cord
through this slot.
Plug the small end of the
telephone base power
adapter into the power
adapter jack on the back
of the telephone base.
Plug the large end of the
telephone base power adapter
into a power outlet not
controlled by a wall switch.
Plug the other end of the
telephone line cord into the
telephone jack on the back of
the telephone base.
If you have DSL high-
speed Internet service, a
DSL lter (not included)
is required.
Route the
telephone line cord
through this slot.
To Next Page
Loading...
Need help?
General
