AT&T CRL32102 - California Energy Commission Battery Charging Testing Instructions

Appendix
29
California Energy Commission battery charging
testing instructions
This telephone is set up to comply with the energy-conserving standards right out of the
box. These instructions are intended for California Energy Commission (CEC) compliance
testing only. When the CEC battery charging testing mode is activated, all telephone
functions, except battery charging, will be disabled.
When first purchased and properly installed for charging (see the Battery installation
and charging section on page 7), put the cordless handset in the handset charger to
charge. The CEC battery charging testing mode is activated while charging.
If you have registered the cordless handset to the CRL32102/CRL32202/CRL32302/
CRL32352/CRL32452 base, below are the testing instructions.
To activate the CEC battery charging testing mode:
1. Unplug the telephone base power adapter from the power outlet. Make sure all
handsets are plugged with charged batteries before proceeding.
2. While you press and hold /HANDSET LOCATOR, plug the telephone base power
adapter back to the power outlet.
3. After about 20 seconds, when the IN USE light starts flashing, release
/HANDSET LOCATOR and then press it again within two seconds.
The process takes up to one minute to complete. When the phone successfully
enters the CEC battery charging testing mode, the IN USE light turns off and all
handsets display To register HS, see manual. You hear a confirmation tone.
When the phone fails to enter this mode, repeat the steps mentioned above.
Note: The telephone base will be powered up as normal if you fail to press
/HANDSET LOCATOR within two seconds in Step 3.
To deactivate the CEC battery charging testing mode:
1. Unplug the telephone base power adapter from the power outlet, then plug it back in.
The telephone base is powered up as normal.
2. Register your handsets back to the telephone base. See pages 8-9 for handset
registration instructions.
BC