AT&T DL72130 - Page 133

127
Appendix
Screen messages
** Paging ** The telephone base is paging all handsets.
Put in charger
The battery is very low. The handset should be placed in the
telephone base or charger.
Quiet mode o Thequietmodeisturnedo.
Quiet mode on The quiet mode is turned on.
Rec mem low The answering system has less than 3 minutes to record.
Rec mem full The answering system memory is full.
Ringer muted The ringer is muted temporarily during an incoming call.
Screen all
Robocalls
You have selected the Screen robotproleoptioninSmartcall
blocker.
Screen all
Unknown calls
You have selected the Screen UnknownproleoptioninSmartcall
blocker.
Screened call
The Smart call blocker feature of the telephone has screened a call
and is putting the call through to you.
Setting Ans sys The handset is playing voice guide.
Smart call blk
screening...
The telephone is screening an incoming call.
Speaker The handset speakerphone is in use.
Voice guide set
Smart call blk?
Aeryouinstallyourtelephoneorpowerreturnsfollowingapower
outage, the handset and telephone base will prompt you to set the
dateandtime.Aerthedateandtimesettingisdoneorskipped,
the telephone base will then prompt if you want to set up the
Smart call blocker feature via voice guide.
To register HS...
...see manual
The handset is not registered to any telephone base.
To screen call
press [SELECT]
The system is recording a message. Press MENU/SELECT to screen a
call on a handset.
Unable to call
X Intercom failed.
X You try to make a call when the handset is out of range.
XX missed calls There are XX new calls in the caller ID log.
XX new messages There are XX new messages in the answering system.