AT&T DL72130 - Telephone Settings; Handset Settings

23
Bluetooth
Bluetooth setup
Connect a paired device
If you need to connect your paired cell phone to the telephone base manually:
1. Press CELL 1 and/or CELL 2 on the telephone base when it is not in use. The
CELL 1 and/or CELL 2lightashes.
2. When the cell phone is connected to the telephone base, you hear two
beeps. The corresponding status icon (
1
or
2
) displays. The corresponding
device light (CELL 1 and/or CELL 2) turns on.
Disconnect a paired device
If you need to disconnect a paired cell phone from the telephone base, refer to
the user’s manuals of your cell phone for instructions to disconnect a Bluetooth
device.
If you press and hold CELL 1 and/or CELL 2 on the telephone base, the existing
paired cell phone in that slot will be erased. See Add a cell phone (page 19)
on how to pair and connect a new cell phone.
Review the device list
1. Press MENU/SELECT on the handset in idle mode.
2. Press CID or DIR to highlight Bluetooth, then
press MENU/SELECT.
3. Press MENU/SELECT again to select Device list.
Bluetooth
ECO
Device list
ECO