AT&T DL72250 - Message Alert Tone

109
Answering system
Answering system settings
Message alert tone
When the message alert tone is set to On, and there is at least one new
message, the telephone base beeps every 10 seconds. The tone stops when all
new messages have been reviewed. By default, the message alert tone is O.
To turn on or o the message alert tone:
1. Press MENU/SELECT in idle mode.
2. Press CID or DIR to highlight Answering sys, then press
MENU/SELECT .
3. Press CID or DIR to highlight Ans sys setup, then press
MENU/SELECT .
4. Press CID or DIR to highlight Msg alert tone, then press
MENU/SELECT .
5. Press CID or DIR to choose On or O, then press
MENU/SELECT .
Notes:
f To temporarily turn o the message alert tone, see page 113.
f The message alert tone beeps only if all the following conditions are met.
– Answering system is on.
– Message alert tone setting is on.
– There are new messages.
Msg alert tone
ECO
Off
ECO