126
Answering system
Answering system settings
Voice guide to set up answering system
This feature is an alternative way for you to do the basic setup of the answering
system. You can follow the voice guide to record your own announcement, set
the number of rings, and set the message alert tone.
To use the voice guide feature:
1. Press MENU/SELECT on the telephone base in idle mode.
2. Press CID or DIR to highlight Answering sys, then
press MENU/SELECT.
3. Press CID or DIR to highlight Voice guide, then press
MENU/SELECT. You hear a voice prompt, “This voice guide
will assist you with the basic setup of your answering
system.“
4. Set up your answering system by inputting designated
numbers, as instructed in the voice guide.
Notes:
f You can press CANCEL on the telephone base to quit the voice guide at any time.
f Aer a power outage, the telephone base prompts you to set the date and time, and Smart call blocker. Aer these
settings are done or skipped, the telephone base then prompts if you want to set up the answering system via voice
guide. Press MENU/SELECT to start the setup.
Answer ON/OFF
>Voice guide
>Answering sys
Smart call blk
To Next Page
Loading...
