EasyManua.ls Logo

AT&T EL52309 - AT&T DECT 6.0 - Product Overview and Setup; Parts Checklist

AT&T EL52309 - AT&T DECT 6.0
8 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2
Battery installation & charging
Install the battery as shown on the next page. After installing the battery, you
might be able to make and receive short calls. For best performance, charge
the handset for at least 16 hours before use. When not in use, place the
handset in the telephone base or charger.
If the battery is depleted, it may take approximately ten minutes to charge the
handset before it shows LOW BATTERY. The screen continues to display LOW
BATTERY until the battery has charged for approximately one hour; the
backlight on the handset disables when in low battery mode.
Battery indicators Battery status Action
The screen is blank. Battery has no charge
and the handset
cannot be used.
Charge until the
screen shows LOW
BATTERY (about 10
minutes).
The screen shows
PLACE IN CHARGER
and flashes.
Battery has very little
charge, the handset
cannot be used.
Charge until the
screen shows LOW
BATTERY (about four
minutes).
The screen shows LOW
BATTERY, flashes,
and you hear four short
beeps every minute.
Battery has enough
charge to be used for a
short time.
Charge until the
screen shows
HANDSET X (about
one hour).
The screen shows
HANDSET X.
Battery is charged. To keep the battery
charged, place it in
the telephone base or
charger when not in
use.

Other manuals for AT&T EL52309 - AT&T DECT 6.0

Related product manuals